AudioCodes Mediant 600 - Management Parameters; General Parameters; Web Parameters; A.2 Management Parameters

SIP User's Manual 554 Document #: LTRT-83310
Mediant 600 & Mediant 1000
A.2 Management Parameters
This subsection describes the device's Web and Telnet parameters.
A.2.1 General Parameters
The general management parameters are described in the table below.
Table A-10: General Management Parameters
Parameter Description
Web: Web and Telnet
Access List Table
EMS: Web Access
Addresses
[WebAccessList_x]
Defines up to ten IP addresses that are permitted to access the device's
Web interface and Telnet interfaces. Access from an undefined IP
address is denied. When no IP addresses are defined in this table, this
security feature is inactive (i.e., the device can be accessed from any IP
address).
The default value is 0.0.0.0 (i.e., the device can be accessed from any IP
address).
For example:
WebAccessList_0 = 10.13.2.66
WebAccessList_1 = 10.13.77.7
For defining the Web and Telnet Access list using the Web interface, see
'Configuring Web and Telnet Access List' on page 70.
Web: Use RADIUS for
Web/Telnet Login
EMS: Web Use Radius
Login
[WebRADIUSLogin]
Enables RADIUS queries for Web and Telnet authentication.
 [0] Disable (default).
 [1] Enable = Logging into the device's Web and Telnet embedded
servers is done through a RADIUS server. The device contacts a
user-defined server and verifies the given user name and password
against a remote database, in a secure manner.
Notes:
 The parameter EnableRADIUS must be set to 1.
 RADIUS authentication requires HTTP basic authentication, meaning
the user name and password are transmitted in clear text over the
network. Therefore, it's recommended to set the parameter
HTTPSOnly to 1 to force the use of HTTPS, since the transport is
encrypted.
 If using RADIUS authentication when logging in to the CLI, only the
primary Web User Account (which has Security Administration
access level) can access the device's CLI (see 'Configuring Web
User Accounts' on page 66).
A.2.2 Web Parameters
The Web parameters are described in the table below.
Table A-11: Web Parameters
Parameter Description
Web: Deny Access On Fail Count
[DenyAccessOnFailCount]
Defines the maximum number of login attempts after which the
requesting IP address is blocked.
The valid value range is 0 to 32768. The values 0 and 1 mean
immediate block. The default is 3.