AudioCodes Mediant 600 - A Configuration Parameters Reference; Networking Parameters; Ethernet Parameters

Version 6.4 543 March 2012
SIP User's Manual A. Configuration Parameters Reference
A Configuration Parameters Reference
The device's configuration parameters, default values, and their descriptions are
documented in this section.
Parameters and values enclosed in square brackets ([...]) represent the ini file parameters
and their enumeration values; parameters not enclosed in square brackets represent their
corresponding Web interface and/or EMS parameters.
Note: Some parameters are configurable only through the ini file.
A.1 Networking Parameters
This subsection describes the device's networking parameters.
A.1.1 Ethernet Parameters
The Ethernet parameters are described in the table below.
Table A-1: Ethernet Parameters
Parameter Description
EMS: Physical Configuration
[EthernetPhyConfiguration]
Defines the Ethernet connection mode type.
 [0] = 10Base-T half-duplex
 [1] = 10Base-T full-duplex
 [2] = 100Base-TX half-duplex
 [3] = 100Base-TX full-duplex
 [4] = Auto-negotiate (default)
Note: For this parameter to take effect, a device reset is required.
[MIIRedundancyEnable]
Enables the Ethernet Interface Redundancy feature. When enabled,
the device performs a switchover to the second (redundant) Ethernet
port upon upon sensing a link failure in the primary Ethernet port.
When disabled, the device operates with a single port (i.e. no
redundancy support).
 [0] = Disable
 [1] = Enable (default)
For more information on Ethernet interface redundancy, see Ethernet
Interface Redundancy on page 102.
Note: For this parameter to take effect, a device reset is required.