AudioCodes Mediant 600 - Message Waiting Indication Parameters

Version 6.4 665 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description

[1] Enable
Web: AS Subscribe
IPGroupID
[ASSubscribeIPGroupID]
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).
Web: NRT Retry
Subscription Time
[NRTSubscribeRetryTime]
Defines the Retry period (in seconds) for Dialog subscription if a
previous request failed.
The valid value range is 10 to 7200. The default is 120.
Web: Call Forward Ring
Tone ID
[CallForwardRingToneID]
Defines the ringing tone type played when call forward notification is
accepted.
The valid value range is 1 to 5. The default is 1.
A.12.5.4 Message Waiting Indication Parameters
The message waiting indication (MWI) parameters are described in the table below.
Table A-44: MWI Parameters
Parameter Description
Web: Enable MWI
EMS: MWI Enable
[EnableMWI]
Enables Message Waiting Indication (MWI).
 [0] Disable = Disabled (default).
 [1] Enable = MWI service is enabled.
Notes:
 This parameter is applicable only to FXS interfaces.
 The device supports only the receipt of SIP MWI NOTIFY
messages (the device doesn't generate these messages).
 For more information on MWI, see 'Message Waiting Indication' on
page 301.
Web/EMS: MWI Analog
Lamp
[MWIAnalogLamp]
Enables the visual display of MWI.
 [0] Disable = Disable (default).
 [1] Enable = Enables visual MWI by supplying line voltage of
approximately 100 VDC to activate the phone's lamp.
Notes:
 This parameter is applicable only for FXS interfaces.
 This parameter can also be configured per Tel Profile (using the
TelProfile parameter).
Web/EMS: MWI Display
[MWIDisplay]
Enables sending MWI information to the phone display.
 [0] Disable = MWI information isn't sent to display (default).
 [1] Enable = The device generates an MWI message (determined
by the parameter CallerIDType), which is displayed on the MWI
display.
Note:
 This parameter is applicable only to FXS interfaces.
 This parameter can also be configured per Tel Profile (using the
TelProfile parameter).
Web: Subscribe to MWI
EMS: Enable MWI
Subscription
Enables subscription to an MWI server.
 [0] No = Disables MWI subscription (default).

[1] Yes = Enables subscription to an MWI server (defined by the