AudioCodes Mediant 600 - Page 666

SIP User's Manual 666 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
[EnableMWISubscription]
parameter MWIServerIP address).
Note: To configure whether the device subscribes per endpoint or per
the entire device, use the parameter SubscriptionMode.
Web: MWI Server IP
Address
EMS: MWI Server IP
[MWIServerIP]
Defines the MWI server's IP address. If provided, the device
subscribes to this IP address. The MWI server address can be
configured as a numerical IP address or as a domain name. If not
configured, the Proxy IP address is used instead.
Web/EMS: MWI Server
Transport Type
[MWIServerTransportType]
Determines the transport layer used for outgoing SIP dialogs initiated
by the device to the MWI server.
 [-1] Not Configured (default)
 [0] UDP
 [1] TCP
 [2] TLS
Note: When set to ‘Not Configured’, the value of the parameter
SIPTransportType is used.
Web: MWI Subscribe
Expiration Time
EMS: MWI Expiration Time
[MWIExpirationTime]
Defines the MWI subscription expiration time in seconds.
The default is 7200 seconds. The range is 10 to 2,000,000.
Web: MWI Subscribe Retry
Time
EMS: Subscribe Retry Time
[SubscribeRetryTime]
Defines the subscription retry time (in seconds) after last subscription
failure.
The default is 120 seconds. The range is 10 to 2,000,000.
Web: Subscription Mode
[SubscriptionMode]
Determines the method the device uses to subscribe to an MWI
server.
 [0] Per Endpoint = Each endpoint subscribes separately - typically
used for FXS interfaces (default).
 [1] Per Gateway = Single subscription for the entire device -
typically used for FXO interfaces.
EMS: ETSI VMWI Type One
Standard
[ETSIVMWITypeOneStand
ard]
Determines the ETSI Visual Message Waiting Indication (VMWI) Type
1 sub-standard.
 [0] = ETSI VMWI between rings (default)
 [1] = ETSI VMWI before ring DT_AS
 [2] = ETSI VMWI before ring RP_AS
 [3] = ETSI VMWI before ring LR_DT_AS
 [4] = ETSI VMWI not ring related DT_AS
 [5] = ETSI VMWI not ring related RP_AS
 [6] = ETSI VMWI not ring related LR_DT_AS
Note: For this parameter to take effect, a device reset is required.
EMS: Bellcore VMWI Type
One Standard
[BellcoreVMWITypeOneSta
ndard]
Determines the Bellcore VMWI sub-standard.
 [0] = Between rings (default).
 [1] = Not ring related.
Note: For this parameter to take effect, a device reset is required.