AudioCodes Mediant 600 - Configuring Redirect Number Tel to IP

SIP User's Manual 262 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
Web/EMS: Suffix to Add The number or string that you want added to the end of the telephone
number. For example, if you enter '00' and the phone number is 1234,
the new number is 123400.
Web/EMS: Number of
Digits to Leave
The number of digits that you want to retain from the right of the phone
number.
Web: Presentation
EMS: Is Presentation
Restricted
Determines whether Caller ID is permitted:
 Not Configured = Privacy is determined according to the Caller ID
table (see Configuring Caller Display Information on page 327).
 [0] Allowed = Sends Caller ID information when a call is made using
these destination / source prefixes.
 [1] Restricted = Restricts Caller ID information for these prefixes.
Notes:
 If 'Presentation' is set to 'Restricted' and the AssertedIdMode
parameter is set to 'P-Asserted', the From header in the INVITE
message includes the following: From: 'anonymous' <sip:
anonymous@anonymous.invalid> and 'privacy: id' header.
Web/EMS: Source IP
Address
Source IP address of the caller (obtained from the Contact header in
the INVITE message).
Note: The source IP address can include the following wildcards:
 "x": represents single digits. For example, 10.8.8.xx denotes all
addresses between 10.8.8.10 and 10.8.8.99.
 "*": represents any number between 0 and 255. For example,
10.8.8.* denotes all addresses between 10.8.8.0 and 10.8.8.255.
Web: TON
EMS: Number Type
The Type of Number (TON) assigned to this entry.
The default is 'Unknown' [0].
 If you select 'Unknown' for the NPI, you can select Unknown [0].
 If you select 'Private' for the NPI, you can select Unknown [0],
International [1], National [2], Network Specific [3] or Subscriber [4].
 If you select 'E.164 Public' for the NPI, you can select Unknown [0],
International [1], National [2], Network Specific [3], Subscriber [4] or
Abbreviated [6].
Web: NPI
EMS: Number Plan
The Numbering Plan Indicator (NPI) assigned to this entry.
 [0] Unknown (default)
 [9] Private
 [1] E.164 Public
 [-1] Not Configured = value received from PSTN/IP is used
Note: For more information on available NPI/TON values, see
'Numbering Plans and Type of Number' on page 266.
18.3.4 Configuring Redirect Number Tel to IP
The Redirect Number Tel > IP page allows you to configure Tel-to-IP Redirect Number
manipulation rules. This feature manipulates the prefix of the redirect number received
from the PSTN for the outgoing SIP Diversion, Resource-Priority, or History-Info header
that is sent to IP.