AudioCodes Mediant 600 - Supplementary Services Parameters; Caller ID Parameters

SIP User's Manual 656 Document #: LTRT-83310
Mediant 600 & Mediant 1000
A.12.5 Supplementary Services Parameters
This subsection describes the device's supplementary telephony services parameters.
A.12.5.1 Caller ID Parameters
The caller ID parameters are described in the table below.
Table A-41: Caller ID Parameters
Parameter Description
Web: Caller ID Permissions Table
EMS: SIP Endpoints > Caller ID
[EnableCallerID]
This parameter table configures Caller ID permissions. It allows you to
enable or disable (per port) Caller ID generation (for FXS interfaces)
and detection (for FXO interfaces).
The format of this parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index = EnableCallerID_IsEnabled,
EnableCallerID_Module, EnableCallerID_Port;
[\EnableCallerID]
Where,
 IsEnabled:

[0] Disable = disables Caller ID (default).

[1] Enable = enables Caller ID generation (FXS) or detection
(FXO).
 Module = Module number (where 1 denotes the module in Slot 1).
 Port = Port number (where 1 denotes Port 1 of a module).
For example:
EnableCallerID 0 = 1,3,1; (caller ID enabled on Port 1 of Module 3)
EnableCallerID 1 = 0,3,2; (caller ID disabled on Port 2 of Module 3)
Notes:
 The indexing of this parameter starts at 0.
 If a port is not configured, its Caller ID generation/detection is
determined according to the global parameter EnableCallerID.
 For configuring this table using the Web interface, see Configuring
Caller ID Permissions on page 329.
 For configuring ini file table parameters, see Configuring ini File
Table Parameters on page 84.
Web: Caller Display Information Table
EMS: SIP Endpoints > Caller ID
[CallerDisplayInfo]
This parameter table enables the device to send Caller ID information
to IP when a call is made. The called party can use this information for
caller identification. The information configured in this table is sent in
the SIP INVITE message's From header.
The format of this parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index = CallerDisplayInfo_DisplayString,
CallerDisplayInfo_IsCidRestricted, CallerDisplayInfo_Module,
CallerDisplayInfo_Port;
[\CallerDisplayInfo]
Where,
 DisplayString = Caller ID string (up to 18 characters).