Version 6.4 137 March 2012
SIP User's Manual 11. Security
11.4 Configuring IP Security Associations Table
The IP Security Associations Table page allows you to configure up to 20 peers (hosts or
networks) for IP security (IPSec)/IKE. Each of the entries in the IPSec Security Association
table controls both Main Mode and Quick Mode configuration for a single peer
Note: You can also configure the IP Security Associations table using the ini file
table parameter IPsecSATable (see 'Security Parameters' on page 568).
To configure the IPSec Association table:
1. Open the ‘IP Security Associations Table page (Configuration tab > VoIP menu >
Security submenu > IPSec Association Table). (Due to the length of the table, the
figure below shows sections of this table.)
Figure 11-3: IP Security Associations Table Page
2. Add an Index or select the Index rule you want to edit.
3. Configure the rule according to the table below.
4. Click Apply; the rule is applied on-the-fly.
5. To save the changes to flash memory, see 'Saving Configuration' on page 482.
Table 11-4: IP Security Associations Table Configuration Parameters
Parameter Name Description
Operational Mode
[IPsecSATable_IPsecMode]
Defines the IPSec mode of operation.
[0] Transport (default)
[1] Tunnel
Remote Endpoint Addr
[IPsecSATable_RemoteEndpoint
AddressOrName]
Defines the IP address or DNS host name of the peer.
Note: This parameter is applicable only if the Operational Mode
is set to Transport.
To Next Page
Loading...
