AudioCodes Mediant 600 - 2 Assigning the Voip LAN IP Address; Using CLI

Version 6.4 23 March 2012
SIP User's Manual 2. Assigning the VoIP LAN IP Address
2 Assigning the VoIP LAN IP Address
This section describes how to change the default VoIP LAN IP address so that it
corresponds to your networking scheme.
The default VoIP LAN IP address is listed in the table below:
Table 2-1: Default VoIP LAN IP Address
IP Address Value
IP Address
10.1.10.10
Subnet Mask
255.255.0.0
Default Gateway IP Address
0.0.0.0
You can use any of the following management tools to change the default VoIP LAN IP
address:

Embedded command line interface (CLI) - see 'Using CLI' on page 23

Embedded HTTP-based Web server - see 'Using the Web Interface' on page 25

Bootstrap Protocol (BootP) - see Using BootP/TFTP Server on page 26

Analog (FXS) telephone voice menu - see Using the FXS Voice Menu Guidance on
page 28
2.1 Using CLI
The procedure below describes how to assign a VoIP LAN IP address, using CLI.
 To assign a LAN IP address using CLI:
1. Connect the RS-232 port of the device to the serial communication port on your
computer. For more information, refer to the Hardware Installation Manual.
Figure 2-1: Connecting to Serial Port for Initial Connectivity – Mediant 1000