Version 6.4 663 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
ToneIndex parameter table.
Playing the call waiting tone according to the parameter
“CallWaitingTone#' of a SIP INFO message.
The device plays the tone received in the 'play tone
CallWaitingTone#' parameter of an INFO message plus the
value of this parameter minus 1.
The valid range is -1 to 1,000. The default value is -1 (i.e., not
used).
Notes:
This parameter is applicable only to analog interfaces.
It is assumed that all Call Waiting Tones are defined in
sequence in the CPT file.
SIP Alert-Info header examples:
Alert-Info:<Bellcore-dr2>
Alert-Info:<http://…/Bellcore-dr2> (where "dr2" defines
call waiting tone #2)
The SIP INFO message is according to Broadsoft's
application server definition. Bel
ow is an example of such an
INFO message:
INFO sip:06@192.168.13.2:5060 SIP/2.0
Via:SIP/2.0/UDP
192.168.13.40:5060;branch=z9hG4bK040066422630
From:
<sip:4505656002@192.168.13.40:5060>;tag=1455352915
To: <sip:06@192.168.13.2:5060>
Call-ID:0010-0008@192.168.13.2
CSeq:342168303 INFO
Content-Length:28
Content-Type:application/broadsoft
play tone CallWaitingTone1
A.12.5.3 Call Forwarding Parameters
The call forwarding parameters are described in the table below.
Table A-43: Call Forwarding Parameters
Parameter Description
Web: Enable Call Forward
[EnableForward]
Enables the Call Forwarding feature.
[0] Disable = Disable the Call Forward service.
[1] Enable = Enable Call Forward service (using REFER) (default).
For FXS interfaces, the Call Forward table (FwdInfo parameter) must
be defined to use the Call Forward service. The device uses REFER
messages for call forwarding.
Note: To use this service, the devices at both ends must support this
option.
Web: Call Forwarding Table
EMS: SIP Endpoints > Call Forward
[FwdInfo]
This parameter table forwards (redirects) IP-to-Tel calls (using SIP 302
response) to other device ports or an IP destination, based on the
To Next Page
Loading...
