SIP User's Manual 506 Document #: LTRT-83310
Mediant 600 & Mediant 1000
24.2 Restoring Defaults using Hardware Reset Button
The device's hardware Reset pinhole button can be used to reset the device to default
settings.
To restore default settings using the hardware Reset button:
With a paper clip or any other similar pointed object, press and hold down the Reset
button (located on the CPU module) for at least 12 seconds (but no more than 25
seconds).
24.3 Restoring Defaults using an ini File
You can restore the device to factory default settings by loading an empty ini file to the
device, using the Web interface's Configuration File page (see 'Backing Up and Loading
Configuration File' on page 503). The only settings that are not restored to default are the
management (OAMP) LAN IP address and the Web interface's login user name and
password. The loaded ini file must be empty (i.e., contain no parameters), or include only
comment signs (i.e., semicolons ";") preceding lines (parameters). The default values
assigned to the parameters are according to the cmp file running on the device.
To Next Page
Loading...
