AudioCodes Mediant 600 - DTMF and Supplementary; Configuring DTMF and Dialing

SIP User's Manual 290 Document #: LTRT-83310
Mediant 600 & Mediant 1000
18.5 DTMF and Supplementary
This section describes configuration of the DTMF and supplementary parameters.
18.5.1 Configuring DTMF and Dialing
The DTMF & Dialing page is used to configure parameters associated with dual-tone multi-
frequency (DTMF) and dialing. For a description of the parameters appearing on this page,
see 'Configuration Parameters Reference' on page 541.
 To configure the DTMF and dialing parameters:
1. Open the DTMF & Dialing page (Configuration tab > VoIP menu > GW and IP to IP
submenu > DTMF & Supplementary submenu > DTMF & Dialing).
2. Configure the parameters as required.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.