AudioCodes Mediant 600 - Resource Allocation Indication Parameters; Bootp Parameters

SIP User's Manual 566 Document #: LTRT-83310
Mediant 600 & Mediant 1000
A.3.3 Resource Allocation Indication Parameters
The Resource Allocation Indication (RAI) parameters are described in the table below.
Table A-17: RAI Parameters
Parameter Description
[EnableRAI]
Enables RAI alarm generation if the device's busy endpoints
exceed a user-defined threshold.
 [0] = Disable RAI (Resource Available Indication) service
(default).
 [1] = RAI service enabled and an SNMP
'acBoardCallResourcesAlarm' Alarm Trap is sent.
[RAIHighThreshold]
Defines the high threshold percentage of total calls that are active
(busy endpoints). When the percentage of the device's busy
endpoints exceeds this high threshold, the device sends the SNMP
acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.
The range is 0 to 100. The default value is 90.
Note: The percentage of busy endpoints is calculated by dividing
the number of busy endpoints by the total number of “enabled”
endpoints (trunks are physically connected and synchronized with
no alarms and endpoints are defined in the Trunk Group Table).
[RAILowThreshold]
Defines the low threshold percentage of total calls that are active
(busy endpoints).
When the percentage of the device's busy endpoints falls below
this low threshold, the device sends an SNMP
acBoardCallResourcesAlarm alarm trap with a 'cleared' alarm
status.
The range is 0 to 100%. The default value is 90%.
[RAILoopTime]
Defines the time interval (in seconds) that the device periodically
checks call resource availability.
The valid range is 1 to 200. The default is 10.
A.3.4 BootP Parameters
The BootP parameters are described in the table below. The BootP parameters are special
'hidden' parameters. Once defined and saved in the device's flash memory, they are used
even if they don't appear in the ini file.
Table A-18: BootP Parameters
Parameter Description
[BootPRetries]
Note: For this parameter to take effect, a device reset is required.
This parameter is used to:
Defines the number of BootP
requests that the device sends
during start-up. The device stops
sending BootP requests when
either BootP reply is received or
number of retries is reached.
 [1] = 1 BootP retry, 1 sec.
 [2] = 2 BootP retries, 3 sec.
 [3] = 3 BootP retries, 6 sec.
Defines the number of DHCP
packets that the device sends. If
after all packets are sent there's
still no reply, the device loads from
flash.
 [1] = 4 DHCP packets
 [2] = 5 DHCP packets
 [3] = 6 DHCP packets (default)
 [4] = 7 DHCP packets