AudioCodes Mediant 600 - Page 664

SIP User's Manual 664 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
device's port to which the call was originally routed.
The format of this parameter is as follows:
[FwdInfo]
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime, FwdInfo_Module, FwdInfo_Port;
[\FwdInfo]
Where,
 Type = the scenario for forwarding the call:

[0] Deactivate = Don't forward incoming calls (default).

[1] On Busy = Forward incoming calls when the port is busy.

[2] Unconditional = Always forward incoming calls.

[3] No Answer = Forward incoming calls that are not answered
within the time specified in the 'Time for No Reply Forward' field.

[4] On Busy or No Answer = Forward incoming calls when the
port is busy or when calls are not answered within the time
specified in the 'Time for No Reply Forward' field.

[5] Do Not Disturb = Immediately reject incoming calls.
 Destination = Telephone number or URI (<number>@<IP address>)
to where the call is forwarded.
 NoReplyTime = Timeout (in seconds) for No Reply. If you have set
the Forward Type for this port to No Answer [3], enter the number of
seconds the device waits before forwarding the call to the specified
phone number.
 Module = Module number (where 1 denotes the module in Slot 1).
 Port = Port number (where 1 denotes Port 1 of a module).
For example:
 Below configuration forwards calls originally destined to Port 1 of
Module 1 to "1001" upon On Busy:
FwdInfo 0 = 1,1001,30,1,1;
 Below configuration forwards calls originally destined to Port 2 of
Module 1 to an IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30,1,2;
Notes:
 The indexing of this parameter starts at 0.
 Ensure that the Call Forward feature is enabled (default) for the
settings of this table parameter to take effect. To enable Call
Forwarding, use the parameter EnableForward.
 If the parameter FwdInfo_Destination only contains a telephone
number and a Proxy isn't used, the 'forward to' phone number must
be specified in the Outbound IP Routing Table (Prefix ini file
parameter).
 For configuring this table using the Web interface, see Configuring
Call Forward on page 328.
 For configuring ini file table parameters, see Configuring ini File
Table Parameters on page 84.
Call Forward Reminder Ring Parameters
Notes:
 These parameters are applicable only to FXS interfaces.
 For a description of this feature, see Call Forward Reminder Ring on page 298.
Web: Enable NRT
Subscription
[EnableNRTSubscription]
Enables endpoint subscription for Ring reminder event notification
feature.
 [0] Disable (default)