SIP User's Manual 226 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Table 17-1: Account Table Parameters Description
Parameter Description
Served Trunk Group
[Account_ServedTrunkGroup]
The Trunk Group ID for which you want to register and/or
authenticate to a destination IP Group (i.e., Serving IP Group).
For Tel-to-IP calls, the Served Trunk Group is the source Trunk
Group from where the call originated. For IP-to-Tel calls, the
Served Trunk Group is the 'Trunk Group ID' defined in the Inbound
IP Routing Table (see 'Configuring the Inbound IP Routing Table'
on page 279). For defining Trunk Groups, see Configuring the
Trunk Group Table on page 251.
Note: For the IP2IP application, this parameter must be set to -1
(i.e., no trunk).
Served IP Group
[Account_ServedIPGroup]
The Source IP Group (e.g., IP-PBX) for which registration and/or
authentication is performed.
Note: This field is applicable only when the IP2IP application is
enabled.
Serving IP Group
[Account_ServingIPGroup]
The destination IP Group ID (defined in 'Configuring IP Groups' on
page 195) to where the REGISTER requests (if enabled) are sent
or authentication is performed. The actual destination to where the
REGISTER requests are sent is the IP address defined for the
Proxy Set ID (see 'Configuring Proxy Sets Table' on page 200)
associated with the IP Group. This occurs only in the following
conditions:
The parameter 'Registration Mode' is set to 'Per Account' in the
Trunk Group Settings table (see 'Configuring Trunk Group
Settings' on page 253).
The parameter 'Register' in this table is set to 1.
In addition, for a SIP call that is identified by both the Served Trunk
Group/Served IP Group and Serving IP Group, the username and
password for digest authentication defined in this table is used.
For Tel-to-IP calls, the Serving IP Group is the destination IP
Group defined in the Trunk Group Settings table or Outbound IP
Routing Table (see 'Configuring the Outbound IP Routing Table' on
page 271). For IP-to-Tel calls, the Serving IP Group is the 'Source
IP Group ID' defined in the Inbound IP Routing Table (see
'Configuring the Inbound IP Routing Table' on page 279).
Note: If no match is found in this table for incoming or outgoing
calls, the username and password defined in the Authentication
table for FXS interfaces (see Configuring Authentication on page
325) or by the global parameters UserName and Password (in the
'Proxy & Registration page) are used.
Username
[Account_Username]
Digest MD5 Authentication user name (up to 50 characters).
Password
[Account_Password]
Digest MD5 Authentication password (up to 50 characters).
Note: After you click the Apply button, this password is displayed
as an asterisk (*).
Host Name
[Account_HostName]
Defines the Address of Record (AOR) host name. It appears in
REGISTER From/To headers as ContactUser@HostName. For
successful registrations, this HostName is also included in the
INVITE request's From header URI. If not configured or if
registration fails, the 'SIP Group Name' parameter from the ‘IP
To Next Page
Loading...
