Version 6.4 119 March 2012
SIP User's Manual 10. Network
3. Click Add New Entry; the new routing rule is added to the IP routing table.
To delete a routing rule from the table, select the 'Delete Row' check box corresponding to
the required routing rule, and then click Delete Selected Entries.
Notes:
• You can delete only inactive routing rules.
• You can also configure the IP Routing table using the ini file table
parameter StaticRouteTable.
Table 10-13: IP Routing Table Description
Parameter Description
Destination IP Address
[StaticRouteTable_Destination]
Specifies the IP address of the destination host/network.
Prefix Length
[StaticRouteTable_PrefixLength]
Specifies the subnet mask of the destination host/network.
The address of the host/network you want to reach is determined by an AND operation that is applied
to the fields 'Destination IP Address' and 'Destination Mask'. For example, to reach the network
10.8.x.x, enter 10.8.0.0 in the field 'Destination IP Address' and 255.255.0.0 in the field 'Destination
Mask'. As a result of the AND operation, the value of the last two octets in the field 'Destination IP
Address' is ignored.
To reach a specific host, enter its IP address in the field 'Destination IP Address' and
255.255.255.255 in the field 'Destination Mask'.
Gateway IP Address
[StaticRouteTable_Gateway]
The IP address of the router (next hop) to which the packets
are sent if their destination matches the rules in the adjacent
columns.
Note: The Gateway address must be in the same subnet as
the IP address of the interface over which you configure this
static routing rule.
Metric The number of hops needed to get to the specified destination.
Note: The recommended value for this parameter is 1. This
parameter must be set to a number greater than 0 for the
routing rule to be valid. Routing entries with Hop Count equals
0 are local routes set automatically by the device.
Interface Name
[StaticRouteTable_InterfaceName]
Assigns a network interface to the routing rule. This value is
the index of the network interface as defined in the Multiple
Interface table (see 'Configuring IP Interface Settings' on page
102).
Note: The IP address of the 'Gateway IP Address' field must
be in the same subnet as this interface's IP address.
Status Read-only field displaying the status of the static IP route:
"Active" - routing rule is used ny the device
"Inactive" - routing rule is not applied
To Next Page
Loading...
