SIP User's Manual 186 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
LCR Call Length
[RoutingRuleGroups_LCR
AverageCallLength]
Defines the average call duration (in minutes) and is used to calculate
the variable portion of the call cost. This is useful, for example, when
the average call duration spans over multiple time bands. The LCR is
calculated as follows: cost = call connect cost + (minute cost * average
call duration)
The valid value range is 0-65533. the default is 1.
For example, assume the following Cost Groups:
"Weekend A": call connection cost is 1 and charge per minute is 6.
Therefore, a call of 1 minute cost 7 units.
"Weekend_ B": call connection cost is 6 and charge per minute is
1. Therefore, a call of 1 minute cost 7 units.
Therefore, for calls under one minute, "Weekend A" carries the lower
cost. However, if the average call duration is more than one minute,
then "Weekend B" carries the lower cost.
Default Cost
[RoutingRuleGroups_LCR
DefaultCost]
Determines whether routing rules in the Outbound IP Routing table
without an assigned Cost Group are considered a higher cost or lower
cost route compared to other matched routing rules that are assigned
Cost Groups.
[0] Min = If the device locates other matching LCR routing rules,
this routing rule is considered the lowest cost route and therefore, it
is selected as the route to use (default.)
[1] Max = If the device locates other matching LCR routing rules,
this routing rule is considered as the highest cost route and
therefore, is not used or used only if the other cheaper routes are
unavailable.
Note: If more than one valid routing rule without a defined Cost Group
exists, the device selects the first-matched rule.
To Next Page
Loading...
