SIP User's Manual 192 Document #: LTRT-83310
Mediant 600 & Mediant 1000
To configure SRDs:
1. Open the SRD Settings page (Configuration tab > VoIP menu > Control Network
submenu > SRD Table).
2. From the 'SRD Index' drop-down list, select an index for the SRD, and then configure
it according to the table below.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.
Note: The SRD Settings page also allows you to define a SIP Interface in the SIP
Interface table, instead of navigating to the SIP Interface Table page as
described in 'Configuring SIP Interface Table' on page 193.
Table 14-1: SRD Table Parameters
Parameter Description
SRD Name
[SRD_Name]
Mandatory descriptive name of the SRD.
The valid value can be a string of up to 21 characters.
Media Realm
[SRD_MediaRealm]
Defines the Media Realm associated with the SRD. The entered string
value must be identical (including case-sensitive) to the Media Realm
name as defined in the Media Realm table.
The valid value is a string of up to 40 characters.
Notes:
If the Media Realm is later deleted from the Media Realm table, then
To Next Page
Loading...
