AudioCodes Mediant 600 - Page 198

SIP User's Manual 198 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
SRD
[IPGroup_SRD]
The SRD (defined in Configuring SRD Table on page 191) associated
with the IP Group.
The default is 0.
Note: For this parameter to take effect, a device reset is required.
Media Realm
[IPGroup_MediaRealm]
Assigns a Media Realm to the IP Group. The entered string value
must be identical (including case-sensitive) to the Media Realm name
as defined in the Media Realm table.
Notes:
 For this parameter to take effect, a device reset is required.
 If the Media Realm is later deleted from the Media Realm table,
then this value becomes invalid.
 For configuring Media Realms, see Configuring Media Realms on
page 169.
IP Profile ID
[IPGroup_ProfileId]
The IP Profile (defined in to 'Configuring IP Profile Settings' on page
219) that you want assigned to this IP Group.
The default is 0.
Gateway Parameters
Always Use Route Table
[IPGroup_AlwaysUseRout
eTable]
Determines the Request-URI host name in outgoing INVITE
messages.
 [0] No (default).
 [1] Yes = The device uses the IP address (or domain name)
defined in the Outbound IP Routing Table (see 'Configuring the
Outbound IP Routing Table' on page 271) as the Request-URI host
name in outgoing INVITE messages instead of the value entered in
the 'SIP Group Name' field.
Note: This parameter is applicable only to SERVER-type IP Groups.
Routing Mode
[IPGroup_RoutingMode]
Defines the routing mode for outgoing SIP INVITE messages.
 [-1] Not Configured = The routing is according to the selected
Serving IP Group. If no Serving IP Group is selected, the device
routes the call according to the Outbound IP Routing Table (see
Configuring Outbound IP Routing Table on page 271). (Default)
 [0] Routing Table = The device routes the call according to the
Outbound IP Routing Table'.
 [1] Serving IP Group = The device sends the SIP INVITE to the
selected Serving IP Group. If no Serving IP Group is selected, the
default IP Group is used. If the Proxy server(s) associated with the
destination IP Group is not alive, the device uses the Outbound IP
Routing Table (if the parameter IsFallbackUsed is set 1, i.e.,
fallback enabled - see Configuring Proxy and Registration
Parameters on page 228).
 [2] Request-URI = The device sends the SIP INVITE to the IP
address according to the received SIP Request-URI host name.
Notes:
 This parameter is applicable only to the IP-to-IP application.
 This parameter is applicable only to SERVER-type IP Groups.
SIP Re-Routing Mode
[IPGroup_SIPReRoutingM
ode]
Determines the routing mode after a call redirection (i.e., a 3xx SIP
response is received) or transfer (i.e., a SIP REFER request is
received).
 [0] Standard = INVITE messages that are generated as a result of
Transfer or Redirect are sent directly to the URI, according to the