SIP User's Manual 210 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Note that only the steps specific to multiple SIP signaling/RTP configuration are described
in detail in the procedure below.
To configure multiple SIP signaling and RTP interfaces:
1. Configure Trunk Group ID #1 in the Trunk Group Table page (Configuration tab >
VoIP menu > GW and IP to IP submenu > Trunk Group > Trunk Group), as shown
in the figure below:
2. Configure the trunk in the Trunk Settings page (Configuration tab > VoIP menu >
GW and IP to IP submenu > Trunk Group > Trunk Group Settings).
3. Configure the IP interfaces in the Multiple Interface table (Configuration tab > VoIP
menu > Network submenu > IP Settings):
Figure 14-5: Defining IP Interfaces (Only Relevant Fields are Shown)
4. Configure Media Realms in the Media Realm table (Configuration tab > VoIP menu >
Media submenu > Media Realm Configuration):
Figure 14-6: Defining Media Realms
5. Configure SRDs in the SRD table (Configuration tab > VoIP menu > Control
Network submenu > SRD Table):
• SRD1 associated with media realm "Realm1".
• SRD2 associated with media realm "Realm2".
Figure 14-7: Defining SRDs
To Next Page
Loading...
