SIP User's Manual 218 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Note: You can also configure Tel Profiles using the ini file table parameter TelProfile
(see 'Configuration Parameters Reference' on page 541).
To configure Tel Profiles:
1. Open the Tel Profile Settings page (Configuration tab > VoIP menu > Coders And
Profiles submenu > Tel Profile Settings).
2. From the 'Profile ID' drop-down list, select the Tel Profile index.
3. In the 'Profile Name' field, enter an arbitrary name that enables you to easily identify
the Tel Profile.
4. From the 'Profile Preference' drop-down list, select the priority of the Tel Profile, where
1 is the lowest priority and 20 the highest. If both IP and Tel profiles apply to the same
call, the coders and other common parameters (noted by an asterisk in the description
of the parameter TelProfile) of the preferred Profile are applied to that call. If the
Preference of the Tel and IP Profiles is identical, the Tel Profile parameters are
applied.
Note: If the coder lists of both IP and Tel Profiles apply to the same call, only the
To Next Page
Loading...
