AudioCodes Mediant 600 - Page 258

SIP User's Manual 258 Document #: LTRT-83310
Mediant 600 & Mediant 1000
 To configure number manipulation rules:
1. Open the required 'Number Manipulation page (Configuration tab > VoIP menu >
GW and IP to IP submenu > Manipulations submenu > Dest Number IP->Tel, Dest
Number Tel->IP, Source Number IP->Tel, or Source Number Tel->IP); the relevant
Manipulation table page is displayed (e.g., 'Source Phone Number Manipulation Table
for TelIP Calls page).
Figure 18-5: Source Phone Number Manipulation Table for Tel-to-IP Calls
The previous figure shows an example of the use of manipulation rules for Tel-to-IP
source phone number manipulation:
• Index 1: When the destination number has the prefix 03 (e.g., 035000), source
number prefix 201 (e.g., 20155), and from source IP Group ID 2, the source
number is changed to, for example, 97120155.
• Index 2: When the source number has prefix 1001 (e.g., 1001876), it is changed
to 587623.
• Index 3: When the source number has prefix 123451001 (e.g., 1234510012001),
it is changed to 20018.
• Index 4: When the source number has prefix from 30 to 40 and a digit (e.g.,
3122), it is changed to 2312.
• Index 5: When the destination number has the prefix 6, 7, or 8 (e.g., 85262146),
source number prefix 2001, it is changed to 3146.
2. Configure the Number Manipulation table according to the table below.
3. Click Submit to apply your changes.
4. To save the changes to flash memory, see 'Saving Configuration' on page 482.
Table 18-8: Number Manipulation Parameters Description
Parameter Description
Source Trunk Group The source Trunk Group ID for Tel-to-IP calls. To denote all Trunk
Groups, leave this field empty.
Notes:
 The value -1 indicates that this field is ignored in the rule.
 This parameter is available only in the 'Source Phone Number
Manipulation Table for Tel -> IP Calls' and 'Destination Phone
Number Manipulation Table for Tel -> IP Calls pages.
 For IP-to-IP call routing, this parameter is not required (i.e., leave
the field empty).
Source IP Group The IP Group from where the IP-to-IP call originated. Typically, this IP
Group of an incoming INVITE is determined/classified using the