AudioCodes Mediant 600 - Page 280

SIP User's Manual 280 Document #: LTRT-83310
Mediant 600 & Mediant 1000
 To configure inbound IP routing rules:
1. Open the Inbound IP Routing Table page (Configuration tab > VoIP menu > GW and
IP to IP submenu > Routing submenu > IP to Trunk Group Routing).
Figure 18-12: Inbound IP Routing Table
The previous figure displays the following configured routing rules:
• Rule 1: If the incoming IP call destination phone prefix is between 10 and 19, the
call is assigned settings configured for IP Profile ID 2 and routed to Trunk Group
ID 1.
• Rule 2: If the incoming IP call destination phone prefix is between 501 and 502,
and source phone prefix is 101, the call is assigned settings configured for IP
Profile ID 1 and routed to Trunk Group ID 2.
• Rule 3: If the incoming IP call has a From URI host prefix as domain.com, the call
is routed to Trunk Group ID 3.
• Rule 4: If the incoming IP call has IP address 10.13.64.5 in the INVITE's Contact
header, the call is identified as an IP-to-IP call and assigned to Source IP Group
4. This call is routed according to the outbound IP routing rules for this Source IP
Group configured in the Outbound IP Routing Table'.
2. From the 'Routing Index' drop-down list, select the range of entries that you want to
add.
3. Configure the inbound IP routing rule according to the table below.
4. Click Submit to apply your changes.
5. To save the changes so they are available after a power failure, see 'Saving
Configuration' on page 482.
Table 18-14: Inbound IP Routing Table Description
Parameter Description
IP to Tel Routing Mode
[RouteModeIP2Tel]
Determines whether to route the incoming IP call before or after
manipulation of destination number (configured in 'Configuring Number
Manipulation Tables' on page 256).
 [0] Route calls before manipulation = Incoming IP calls are routed
before number manipulation (default).
 [1] Route calls after manipulation = Incoming IP calls are routed after
number manipulation are applied.
Dest. Host Prefix The Request-URI host name prefix of the incoming SIP INVITE message.
If this routing rule is not required, leave the field empty.
Note: The asterisk (*) wildcard can be used to denote any prefix.