SIP User's Manual 366 Document #: LTRT-83310
Mediant 600 & Mediant 1000
The figure below provides an illustration of this example scenario:
Figure 18-48: SIP Trunking Setup Scenario Example
The steps for configuring the device according to the scenario above can be summarized
as follows:
Enable the IP-to-IP feature (see 'Step 1: Enable the IP-to-IP Capabilities' on page
367).
Configure the number of media channels (see 'Step 2: Configure the Number of Media
Channels' on page 367).
Configure a Trunk Group for interfacing with the local PSTN (see 'Step 3: Define a
Trunk Group for the Local PSTN' on page 368).
Configure Proxy Sets (see 'Step 4: Configure the Proxy Sets' on page 368).
Configure IP Groups (see 'Step 5: Configure the IP Groups' on page 370).
Configure Registration Accounts (see 'Step 6: Configure the Account Table' on page
373).
Configure IP Profiles (see 'Step 7: Configure IP Profiles for Voice Coders' on page
374).
Configure inbound IP routing rules (see 'Step 8: Configure Inbound IP Routing' on
page 376).
Configure outbound IP routing rules (see 'Step 9: Configure Outbound IP Routing' on
page 377).
Configure destination phone number manipulation (see 'Step 10: Configure
Destination Phone Number Manipulation' on page 380).
To Next Page
Loading...
