SIP User's Manual 590 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
Web: Gateway
Registration Name
EMS: Name
[GWRegistrationName]
Defines the user name that is used in the From and To headers in SIP
REGISTER messages. If no value is specified (default) for this
parameter, the UserName parameter is used instead.
Note:
This parameter is applicable only for single registration per device
(i.e., AuthenticationMode is set to 1). When the device registers each
channel separately (i.e., AuthenticationMode is set to 0), the user name
is set to the channel's phone number.
Web/EMS: Registration
Mode
[AuthenticationMode]
Determines the device's registration and authentication method.
[0] Per Endpoint = Registration and authentication is performed
separately for each endpoint/B-channel. This is typically used for
FXS interfaces, where each endpoint registers (and authenticates)
separately with its user name and password.
[1] Per Gateway = Single registration and authentication for the
entire device (default). This is typically used for FXO interfaces and
digital modules.
[3] Per FXS = Registration and authentication for FXS endpoints.
Web: Set Out-Of-Service
On Registration Failure
EMS: Set OOS On
Registration Fail
[OOSOnRegistrationFail]
Enables setting an endpoint, trunk, or the entire device (i.e., all
endpoints) to out-of-service if registration fails.
[0] Disable (default)
[1] Enable
If the registration is per endpoint (i.e., AuthenticationMode is set to 0) or
per Account (see 'Configuring Trunk Group Settings' on page 253) and
a specific endpoint/Account registration fails (SIP 4xx or no response),
then that endpoint is set to out-of-service until a success response is
received in a subsequent registration request. When the registration is
per the entire device (i.e., AuthenticationMode is set to 1) and
registration fails, all endpoints are set to out-of-service. If all the
Accounts of a specific Trunk Group fail registration and if the Trunk
Group comprises a complete trunk, then the entire trunk is set to out-of-
service.
Note: Te out-of-service method is configured using the parameter
FXSOOSBehavior.
[UnregistrationMode]
Enables the device to perform explicit unregisters.
[0] Disable (default)
[1] Enable = The device sends an asterisk ("*") value in the SIP
Contact header, instructing the Registrar server to remove all
previous registration bindings. The device removes SIP User Agent
(UA) registration bindings in a Registrar, according to RFC 3261.
Registrations are soft state and expire unless refreshed, but they can
also be explicitly removed. A client can attempt to influence the
expiration interval selected by the Registrar. A UA requests the
immediate removal of a binding by specifying an expiration interval of
"0" for that contact address in a REGISTER request. UA's should
support this mechanism so that bindings can be removed before
their expiration interval has passed. Use of the "*" Contact header
field value allows a registering UA to remove all bindings associated
with an address-of-record (AOR) without knowing their precise
values.
Note: The REGISTER-specific Contact header field value of "*" applies
to all registrations, but it can only be used if the Expires header field is
present with a value of "0".
Enables the inclusion of the SIP Authorization header in initial
To Next Page
Loading...
