AudioCodes Mediant 600 - Page 625

Version 6.4 625 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
IpProfile_RxDTMFO
ption
Declare RFC 2833 in
SDP
RxDTMFOption
IpProfile_EnableHol
d
Enable Hold EnableHold
IpProfile_InputGain
Input Gain InputGain
IpProfile_VoiceVolu
me
Voice Volume VoiceVolume
IpProfile_AddIEInSe
tup
Add IE In SETUP AddIEinSetup
IpProfile_MediaIPVe
rsionPreference
Media IP Version
Preference
MediaIPVersionPreference
IpProfile_Transcodi
ngMode
Transcoding Mode TranscodingMode
IpProfile_EnableQSI
GTunneling
- EnableQSIGTunneling
IpProfile_AMDSensit
ivityParameterSuit
AMD Sensitivity Level AMDSensitivityLevel
IpProfile_AMDSensit
ivityLevel
AMD Sensitivity Level AMDSensitivityLevel
IpProfile_AMDMaxG
reetingTime
AMD Max Greeting
Time
AMDMaxGreetingTime
IpProfile_AMDMaxP
ostSilenceGreetingT
ime
AMD Max Post
Silence Greeting
Time
AMDMaxPostGreetingSile
nceTime
 The parameter IpPreference determines the priority of the IP Profile (1 to
20, where 20 is the highest preference). If both IP and Tel Profiles apply to
the same call, the coders and common parameters (i.e., parameters
configurable in both IP and Tel Profiles) of the preferred profile are applied
to that call. If the Tel and IP Profiles are identical, the Tel Profile
parameters take precedence.
 The parameter CallLimit defines the maximum number of concurrent calls
allowed for that Profile. If the Profile is set to some limit, the device
maintains the number of concurrent calls (incoming and outgoing)
pertaining to the specific Profile. A limit value of [-1] indicates that there is
no limitation on calls (default). A limit value of [0] indicates that all calls are
rejected. When the number of concurrent calls is equal to the limit, the
device rejects any new incoming and outgoing calls pertaining to that
profile.
 RxDTMFOption configures the received DTMF negotiation method: [-1] not
configured, use the global parameter; [0] don’t declare RFC 2833; [1]
declare RFC 2833 payload type is SDP.

FirstTxDtmfOption and SecondTxDtmfOption configures the transmit DTMF
negotiation method: [-1] not configured, use the global parameter; for the
remaining options, see the global parameter.

The VxxTransportType parameter configures the modem transport type per
IP Profile for the following parameters: V21ModemTransportType,
V22ModemTransportType, V23ModemTransportType,