AudioCodes Mediant 600 - Page 660

SIP User's Manual 660 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
includes the value 'id' ('Privacy: id'). Otherwise, for allowed Caller ID,
'Privacy: none' is used. If Caller ID is restricted (received from Tel or
configured in the device), the From header is set to
<anonymous@anonymous.invalid>.
The 200 OK response can contain the connected party CallerID -
Connected Number and Connected Name. For example, if the call is
answered by the device, the 200 OK response includes the P-
Asserted-Identity with Caller ID. The device interworks (in some ISDN
variants), the Connected Party number and name from Q.931 Connect
message to SIP 200 OK with the P-Asserted-Identity header. In the
opposite direction, if the ISDN device receives a 200 OK with P-
Asserted-Identity header, it interworks it to the Connected party
number and name in the Q.931 Connect message, including its
privacy.
Web: Use Destination As
Connected Number
[UseDestinationAsConnec
tedNumber]
Determines whether the device includes the Called Party Number from
outgoing Tel calls (after number manipulation) in the SIP P-Asserted-
Identity header. The device includes the SIP P-Asserted-Identity
header in 180 Ringing and 200 OK responses for IP-to-Tel calls.
 [0] Disable (default)
 [1] Enable
Notes:
 If the received Q.931 Connect message contains a Connected
Party Number, this number is used in the P-Asserted-Identity
header in 200 OK response.
 For this feature, you must also enable the device to include the P-
Asserted-Identity header in 180/200 OK responses, by setting the
parameter AssertedIDMode to 1.
 This parameter is applicable to ISDN, CAS, and/or FXO interfaces.
Web: Caller ID Transport
Type
EMS: Transport Type
[CallerIDTransportType]
Determines the device's behavior for Caller ID detection.
 [0] Disable = The caller ID signal is not detected - DTMF digits
remain in the voice stream.
 [1] Relay = (Currently not applicable.)
 [3] Mute = The caller ID signal is detected from the Tel/PSTN side
and then erased from the voice stream (default).
Note: Caller ID detection is applicable only to FXO interfaces.