Version 6.4 709 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
Web: IPMedia Detectors
EMS: DSP Detectors Enable
[EnableDSPIPMDetectors]
Enables the device's DSP detectors.
[0] = Disable (default).
[1] = Enable.
Notes:
For this parameter to take effect, a device reset is required.
The device's Software Upgrade Key must contain the
'IPMDetector' DSP option.
When enabled (1), the number of available channels is
reduced.
Web: Add IE in SETUP
EMS: IE To Be Added In Q.931
Setup
[AddIEinSetup]
Adds an optional Information Element (IE) data (in hex format)
to ISDN Setup messages. For example, to add IE
'0x20,0x02,0x00,0xe1', enter the value "200200e1".
Notes:
This IE is sent from the Trunk Group IDs that are defined by
the parameter SendIEonTG.
You can configure different IE data for Trunk Groups by
defining this parameter for different IP Profile IDs (using the
IPProfile parameter) and then assigning the required IP
Profile ID in the Inbound IP Routing Table (PSTNPrefix).
This feature is similar to that of the
EnableISDNTunnelingIP2Tel parameter. If both parameters
are configured, the EnableISDNTunnelingIP2Tel parameter
takes precedence.
Web: Trunk Groups to Send IE
EMS: List Of Trunk Groups To
Send IE
[SendIEonTG]
Defines Trunk Group IDs (up to 50 characters) from where the
optional ISDN IE (defined by the parameter AddIEinSetup) is
sent. For example: '1,2,4,10,12,6'.
Notes:
You can configure different IE data for Trunk Groups by
defining this parameter for different IP Profile IDs (using the
parameter IPProfile), and then assigning the required IP
Profile ID in the Inbound IP Routing Table (PSTNPrefix).
When IP Profiles are used for configuring different IE data
for Trunk Groups, this parameter is ignored.
Web: Enable User-to-User IE for
Tel to IP
EMS: Enable UUI Tel 2 Ip
[EnableUUITel2IP]
Enables ISDN PRI-to-SIP interworking.
[0] Disable = Disabled (default).
[1] Enable = Enable transfer of User-to-User (UU) IE from
PRI to SIP.
The device supports the following ISDN PRI-to-SIP
interworking: Setup to SIP INVITE, Connect to SIP 200 OK,
User Information to SIP INFO, Alerting to SIP 18x response,
and Disconnect to SIP BYE response messages.
Note: The interworking of ISDN User-to-User IE to SIP INFO is
applicable only to the Euro ISDN, QSIG, and 4ESS PRI
variants.
Web: Enable User-to-User IE for IP
to Tel
EMS: Enable UUI Ip 2 Tel
[EnableUUIIP2Tel]
Enables SIP-to-PRI ISDN interworking.
[0] Disable = Disabled (default).
[1] Enable = Enable transfer of User-to-User (UU) IE from
SIP INVITE message to PRI Setup message.
The device supports the following SIP-to-PRI ISDN
interworking: SIP INVITE to Setup, SIP 200 OK to Connect, SIP
To Next Page
Loading...
