AudioCodes Mediant 600 - Page 716

SIP User's Manual 716 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
BrokenConnectionEventTimeout parameter.
 This feature is applicable only if the RTP session is used
without Silence Compression. If Silence Compression is
enabled, the device doesn't detect a broken RTP connection.
 During a call, if the source IP address (from where the RTP
packets are received) is changed without notifying the device,
the devic
e filters these RTP packets. To overcome this, set the
DisconnectOnBrokenConnection parameter to 0; the device
doesn't detect RTP packets arriving from the original source IP
address and switches (after 300 msec) to the RTP packets
arriving from the new source IP address.

This parameter can also be configured per IP Profile, using the
IPProfile parameter (see 'Configuring IP Profiles' on page
219).
Web: Broken Connection
Timeout
EMS: Broken Connection Event
Timeout
[BrokenConnectionEventTimeo
ut]
Defines the time period (in 100-msec units) after which a call is
disconnected if an RTP packet is not received.
The valid range is from 3 (i.e., 300 msec) to an unlimited value
(e.g., 20 hours). The default value is 100 (i.e., 10000 msec or 10
seconds).
Notes:
 This parameter is applicable only if the parameter
DisconnectOnBrokenConnection is set to 1.
 Currently, this feature functions only if Silence Suppression is
disabled.
Web: Disconnect Call on Silence
Detection
EMS: Disconnect On Detection
Of Silence
[EnableSilenceDisconnect]
Determines whether calls are disconnected after detection of
silence.
 [1] Yes = The device disconnects calls in which silence occurs
(in both call directions) for more than a user-defined time.
 [0] No = Call is not disconnected when silence is detected
(default).
The silence duration can be configured by the
FarEndDisconnectSilencePeriod parameter (default 120).
Note: To activate this feature, set the parameters
EnableSilenceCompression and
FarEndDisconnectSilenceMethod to 1.
Web: Silence Detection Period
[sec]
EMS: Silence Detection Time Out
[FarEndDisconnectSilencePeri
od]
Defines the duration of the silence period (in seconds) after which
the call is disconnected.
The range is 10 to 28,800 (i.e., 8 hours). The default is 120
seconds.
Note: For this parameter to take effect, a device reset is required.
Web: Silence Detection Method
[FarEndDisconnectSilenceMeth
od]
Determines the silence detection method.
 [0] None = Silence detection option is disabled.
 [1] Packets Count = According to packet count.
 [2] Voice/Energy Detectors = N/A.
 [3] All = N/A.
Note: For this parameter to take effect, a device reset is required.
[FarEndDisconnectSilenceThre
shold]
Defines the threshold of the packet count (in percentages) below
which is considered silence by the device.
The valid range is 1 to 100%. The default is 8%.
Notes:

This parameter is applicable only if silence is detected