Version 6.4 721 March 2012
SIP User's Manual A. Configuration Parameters Reference
Parameter Description
The valid range is 0 to 254. The default is 0 seconds.
Typically, after playing a Reorder/Busy tone for the specified duration,
the device starts playing an Offhook Warning tone.
For Digital: Defines the duration (in seconds) that the CAS device plays
a Busy or Reorder Tone before releasing the line.
The valid range is 0 to 254. The default value is 10.
Notes:
The selection of Busy or Reorder tone is performed according to the
release cause received from IP.
This parameter is also applicable for ISDN when
PlayBusyTone2ISDN is set to 2.
This parameter can also be configured per Tel Profile, using the
TelProfile parameter).
Web: Time Before Reorder
Tone [sec]
EMS: Time For Reorder
Tone
[TimeBeforeReorderTone
]
Defines the delay interval (in seconds) from when the device receives a
SIP BYE message (i.e., remote party terminates call) until the device
starts playing a Reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Web: Cut Through Reorder
Tone Duration [sec]
[CutThroughTimeForReO
rderTone]
Defines the duration (in seconds) of the Reorder tone played to the
PSTN side after the IP call party releases the call, for the Cut-Through
feature. After the tone stops playing, an incoming call is immediately
answered if the FXS is off-hooked (for analog interfaces) or the PSTN is
connected (for digital interfaces).
The valid values are 0 to 30. The default is 0 (i.e., no Reorder tone is
played).
Note: To enable the Cut-Through feature, use the DigitalCutThrough
(for CAS channels) or CutThrough (for FXS channels) parameters.
Web/EMS: Enable Comfort
Tone
[EnableComfortTone]
Determines whether the device plays a Comfort Tone (Tone Type #18)
to the FXS/FXO endpoint after a SIP INVITE is sent and before a SIP
18x response is received.
[0] Disable (default)
[1] Enable
Note: This parameter is applicable to FXS and FXO interfaces.
[WarningToneDuration]
Defines the duration (in seconds) for which the Off-Hook Warning Tone
is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Notes:
A negative value indicates that the tone is played infinitely.
This parameter is applicable only to analog interfaces.
Web: Play Busy Tone to
Tel
[PlayBusyTone2ISDN]
Enables the device to play a busy or reorder tone to the PSTN after a
Tel-to-IP call is released.
[0] Don't Play = Immediately sends an ISDN Disconnect message
(default).
[1] Play when Disconnecting = Sends an ISDN Disconnect message
with PI = 8 and plays a busy or reorder tone to the PSTN (depending
on the release cause).
[2] Play before Disconnect = Delays the sending of an ISDN
Disconnect message for a user-defined time (configured by the
TimeForReorderTone parameter) and plays a busy or reorder tone to
To Next Page
Loading...
