SIP User's Manual 736 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
For configuring this table in the Web interface, see Configuring
Trunk Group Table on page 251.
For a description of ini file table parameters, see 'Configuring ini
File Table Parameters' on page 84.
Trunk Group Settings
Web: Trunk Group Settings
EMS: SIP Routing > Hunt
Group
[TrunkGroupSettings]
This parameter table defines rules for channel allocation per Trunk
Group. If no rule exists, the rule defined by the global parameter
ChannelSelectMode takes effect. The format of this parameter is
as follows:
[TrunkGroupSettings]
FORMAT TrunkGroupSettings_Index =
TrunkGroupSettings_TrunkGroupId,
TrunkGroupSettings_ChannelSelectMode,
TrunkGroupSettings_RegistrationMode,
TrunkGroupSettings_GatewayName,TrunkGroupSettings_Contact
User, TrunkGroupSettings_ServingIPGroup,
TrunkGroupSettings_MWIInterrogationType;
[\TrunkGroupSettings]
Where,
MWIInterrogationType = defines QSIG MWI to IP interworking
for interrogating MWI supplementary services:
[255] Not Configured
[0] None = disables the feature.
[1] Use Activate Only = don't send any MWI Interrogation
messages and only "passively" respond to MWI Activate
requests from the PBX.
[2]
Result Not Used = send MWI Interrogation message, but
don't use its result. Instead, wait for MWI Activate requests
from the PBX.
[3] Use Result = send MWI Interrogation messages, use its
results, and use the MWI Activate requests.
MWI Activate requests are interworked to SIP NOTIFY MWI
messages. The SIP NOTIFY messages are sent to the IP
Group defined by the NotificationIPGroupID parameter.
For example:
TrunkGroupSettings 0 = 1, 0, 5, branch-hq, user, 1, 255;
TrunkGroupSettings 1 = 2, 1, 0, localname, user1, 2, 255;
Notes:
This parameter can include up to 120 indices.
For configuring Trunk Group Settings using the Web interface,
see 'Configuring Trunk Group Settings' on page 253.
For a description on using ini file table parameters, see to
'Configuring ini File Table Parameters' on page 84.
Web: Channel Select Mode
EMS: Channel Selection Mode
[ChannelSelectMode]
Method for allocating incoming IP-to-Tel calls to a channel.
[0] By Dest Phone Number = Selects the channel according to
the called (destination) number (default). If the number is not
located, the call is released. If the channel is unavailable (e.g.,
busy), the call is put on call waiting (if call waiting is enabled and
no other call is on call waiting); otherwise, the call is released.
[1] Cyclic Ascending = Selects the next avail
Trunk Group) in an ascending cyclic order. When the device
reaches the highest channel number in the Trunk Group, it
selects the lowest channel number in the Trunk Group and then
To Next Page
Loading...
