AudioCodes Mediant 600 - Page 756

SIP User's Manual 756 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
Web/EMS: Swap Redirect and
Called Numbers
[SwapRedirectNumber]
 [0] No = Don't change numbers (default).
 [1] Yes = Incoming ISDN call that includes a redirect number
(sometimes referred to as 'original called number') uses the
redirect number instead of the called number.
[SwapTel2IPCalled&CallingNum
bers]
Determines whether the device swaps the calling and called
numbers received from the Tel side (for Tel-to-IP calls). The SIP
INVITE message contains the swapped numbers.
 [0] = Disabled (default)
 [1] = Swap calling and called numbers
Note: This parameter can also be configured per Tel Profile,
using the TelProfile parameter.
Web: Add NPI and TON to redirect
Number
[AddNPIandTON2RedirectNumb
er]
Determines whether the NPI and TON values are added as the
prefix to the Redirect number in the INVITE message's
Diversion or History-Info headers, for ISDN Tel-to-IP calls.
 [0] Yes (Default)
 [1] No
Web/EMS: Add Prefix to Redirect
Number
[Prefix2RedirectNumber]
Defines a string prefix that is added to the Redirect number
received from the Tel side. This prefix is added to the Redirect
Number in the SIP Diversion header.
The valid range is an 8-character string. The default is an empty
string.
Web: Add Number Plan and Type
to RPI Header
EMS: Add Ton 2 RPI
[AddTON2RPI]
Determines whether the TON/PLAN parameters are included in
the Remote-Party-ID (RPID) header.
 [0] No
 [1] Yes (default)
If the Remote-Party-ID header is enabled (EnableRPIHeader =
1) and AddTON2RPI = 1, it's possible to configure the calling
and called number type and number plan using the Number
Manipulation tables for Tel-to-IP calls.
Web/EMS: Source Manipulation
Mode
[SourceManipulationMode]
Determines the SIP headers containing the source number after
manipulation:
 [0] = The SIP From and P-Asserted-Identity headers contain
the source number after manipulation (default).
 [1] = Only SIP From header contains the source number
after manipulation, while the P-Asserted-Identity header
contains the source number before manipulation.
Calling Name Manipulations IP-to-Tel Table
[CallingNameMapIp2Tel]
Configures rules for manipulating the calling name (caller ID) in
the received SIP message for IP-to-Tel calls. This can include
modifying or removing the calling name. The format of this ini
file parameter table is as follows:
[ CallingNameMapIp2Tel ]
FORMAT CallingNameMapIp2Tel_Index =
CallingNameMapIp2Tel_DestinationPrefix,
CallingNameMapIp2Tel_SourcePrefix,
CallingNameMapIp2Tel_CallingNamePrefix,
CallingNameMapIp2Tel_SourceAddress,
CallingNameMapIp2Tel_RemoveFromLeft,
CallingNameMapIp2Tel_RemoveFromRight,
CallingNameMapIp2Tel_LeaveFromRight,
CallingNameMapIp2Tel_Prefix2Add,