AudioCodes Mediant 600 - Page 780

SIP User's Manual 780 Document #: LTRT-83310
Mediant 600 & Mediant 1000
Parameter Description
[VxmlSystemInputModes]
Determines which inputs are valid for grammars.
 [0] = DTMF is valid (default)
 [1] = Voice is valid
 [2] = Both are valid
Note: For this parameter to take effect, a device reset is required.
[VxmlTermChar]
Defines the default terminating digit for received DTMF.
The default value is 35 (equivalent to ASCII '#').
Note: For this parameter to take effect, a device reset is required.
[VxmlTermTimeout]
Defines the time to wait before terminating received DTMF (in msec).
The range is 0 - 7,000. The default value is 3,000.
Note: For this parameter to take effect, a device reset is required.
Media Resource Control Protocol (MRCP) / Real Time Streaming Protocol (RTSP) Parameters
[MRCPDefaultMIMEType]
Determines the default format for speech recognition for inline
grammars.
 [0] = indicates GRXML (default)
 [1] = indicates GL (Nuance format)
[MRCPEnabled]
Activates the Media Resource Control Protocol (MRCP) functionality.
 [0] = Disable (default)
 [1] = Activate
[MRCPMaxPorts]
Defines the number of ports that are allocated to running MRCP-
related activities such as speech recognition and text-to-speech. A
port is considered duplex, so that speech recognition and text-to-
speech can run on the same port.
The value should not exceed the number of channels in the system.
The range is 0 - 120. The default value is 10.
[MRCPServerName]
Defines the hostname of the MRCP server. This is used to build a
URI for the server.
The default value is NULL.
[MRCPServerIp]
Defines the IP address of the MRCP speech server.
The default value is 0.0.0.0.
[MRCPServerPort]
Defines the control port on the MRCP speech server.
The range is 0 - 65,535. The default value is 554.
[RTSPConnectionRetryInter
val]
Defines the time (in seconds) that the system must wait before trying
to create a socket for the RTSP speech server if the socket was
never created or was created and then brought down.
The range is 0 - 65,535. The default value is 10.
Note: For this parameter to take effect, a device reset is required.
[RTSPEnabled]
Activates the RTSP functionality.
 [0] = Disable (default)
 [1] = Activate
Note: For this parameter to take effect, a device reset is required.
[RTSPMaxPorts]
Defines the number of channels that can be simultaneously active in
RTSP sessions.
The range is 0 - 20.The default value is 10.
Note: For this parameter to take effect, a device reset is required.