ST80 Masterview Operation and Setup
101
Chapter 2: Setup
2.1 About this Chapter
This chapter describes how, using a combination of flow charts,
diagrams and text, to set and adjust features contained in the User
Setup menus.
These flow charts show the display roll-over for a particular key or
key sequence. If a display is adjustable, related information follows
the flow chart in the order of appearance.
2.2 Initial Start-up
When the Masterview is powered up for the first time you are
presented with the “SELECT TYPE” display. Use this page to select
your vessel type (sail or power).
masterview
D2227-1
Press to advance to the next
chapter. Press for 1 second
to select illumination
adjustment.
Highlight previous option.
Highlight next option.
SELECT TYPE
✕
SAIL BOAT
POWER BOAT
✓
Switch highlighted option
ON/OFF
or
Points to remember...
• The selected mode is identified by a ✔.
• Deselected modes are identified by a ✖.
• The “SELECT TYPE” display defaults to “SAIL” if a permanent
selection has not been made.
• Depending on your select type selection, the order in which the
displays appear may differ from those in this chapter.
To Next Page
Loading...
Need help?
General
