ST80 Masterview Operation and Setup 69
What if a waypoint is not selected?
A “no waypoint selected” pop-up is displayed if a target waypoint
has not been selected. Normal data fields are replaced by dashes and
the right-hand keypad icon is removed.
D2149-1
NOT TRACKING
TO WAYPOINT
Auto Steer
This page displays the locked heading, a direction-to-steer indicator
and any off course error.
D2275-1
Go to the next chapter or
press for 1 second to enter
illumination adjustment.
Go to the next page or
press for 1 second to return
to the previous page.
masterview
Display vane/steer page.
AUTO STEER
+001
120o
TRUE
• This page is only available when the autopilot is in AUTO mode.
• This page is directly linked to the locked autopilot heading.
• There are basically two operating modes: current and fixed. Current
displays the current autopilot heading (identified by a ~) together
with a positive or negative autopilot heading error. Fixed mode
displays the locked autopilot heading and a positive or negative
autopilot heading error.
To Next Page
Loading...
Need help?
General
