AUTOHELM ST80 - Entering a New Code; Turning Codelock off

ST80 Masterview Operation and Setup
145
Entering a New Code
D2679-1
Exit new code entry and
save new code number.
Increase highlighted field
by 1
Decrease highlighted field
by 1
Highlight next code number
field.
masterview
SET- UP
CODELOCK
NEW CODE
▼
▼
▼
▼
• The code number will not be stored if you exit new code entry with a
dash present in the code number.
Turning CodeLock Off
To turn CodeLock off you must enter the correct code number (using
the keys as shown) and quit by pressing the exit key.
D2680-1
Exit code entry and turn
codelock off.
Increase highlighted field
by 1
Decrease highlighted field
by 1
Highlight next code number
field.
masterview
SET- UP
CODELOCK
ENTER CODE
▼
▼
▼
▼
• The display returns to the CodeLock setup page when a code is
cleared.
• A message is displayed for 4 seconds if an incorrect code is entered.
• This message will be displayed for 60 seconds if an incorrect code is
entered on three consecutive occasions.