ST80 Masterview Operation and Setup
131
Drive Option
The drive option sets the type of drive used by your vessel.
D2658-1
Go to the Setup Exit page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
STEERING TYPE
SOFT XDUCER
The available options are:
(a) Soft + tacho (for diagnostics use only)
(b) Hard + tacho (for diagnostics use only)
(c) Soft + Xducer (For mechanical drives)
(d) Hard + Xducer (for hydraulic drives)
Rudder Deadband (Damping)
The factory default for the rudder deadband provides a stable rudder
position on most steering systems. However, some steering systems
that use rotary or hydraulic drives a long way from the rudder may
experience slight instability. This instability can be minimised by
increasing the rudder deadband.
D2659-1
Go to the Setup Exit page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
RUDDER DAMPING
4
The damping range is from 1 to 9 (the factory default is 1).
Caution: Increasing this setting will reduce the steering accuracy. It is
important, therefore, to use the minimum setting necessary for stable
operation.
To Next Page
Loading...
Need help?
General
