ST80 Masterview Operation and Setup
129
Off Course Limit
Off course limit tells you if the autopilot is unable to maintain its set
course, and has subsequently strayed by more than the set limit for
more than 20 seconds.
D2655-1
Go to the Pilot Setup Exit
page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
OFF COURSE LIMIT
22
• The range is 15 to 40°.
• The default setting is 20°.
Trim Level
This sets the level for automatic trim. This applies additional rudder
to correct for weather helm and other causes of static heading errors.
D2657-1
Go to the Setup Exit page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
TRIM LEVEL
3
The trim level settings available are: 0, 1, 2, 3 and 4
(a) Heavy displacement: 1
(b) Displacement: 2
(c) Semi displacement: 3
(d) Planing and Stern drive: 3
(e) Fast Planing: 4
To Next Page
Loading...
