ST80 Masterview Operation and Setup 55
Leg Information
This page displays information related to the legs of a journey (see
below).
• If you are tracking a single waypoint or there is no current route,
‘NO ROUTE’ is displayed and the cycle key is disabled.
Single Waypoint Page
This page is used to display, create, and track a single destination
waypoint using Lat/Lon or ranges and bearings and is designed to
provide a quick method of entering a single waypoint as an
alternative to using Waypoint List and Route Planning.
Note: If a pop-up message “TARGET WPT” or “TRACKING WPT” is
displayed on this page, then an active waypoint exists via another
source (Route page or another Masterview/ Navigator). This
waypoint will need to be switched off before the Single Waypoint
function can be used.
Creating a Single Destination Waypoint
D2260-1
Go to next chapter or press
for 1 second to enter
illumination adjustment.
Go to next page.
Press for 1 second to go to
previous page.
masterview
SINGLE WP
020 23.82 N
052 04.02 E
WP
WP
Select track to a single
waypoint mode.
Display single waypoint
editing icons.
To Next Page
Loading...
Need help?
General
