AUTOHELM ST80 User Manual

44 ST80 Masterview Operation and Setup
If linking has not taken place, information can be entered or
modified from any Navigator keypad.
Waypoints
Before you begin to generate a route, you must create and store
waypoints in the waypoint list.
Entering New Waypoints
Cycle the Navigate Chapter until you come to ‘Waypoint List’ and
then follow the instructions below:
Use these keys to enter the name and
co-ordinates for the new waypoint.
Each key cycles the number and the
letters printed on that key (e.g. cycle of
key 1 is 1, a, b, c, 1 etc.)
Use these keys to insert or delete data
at the cursor position.
Use the multi-directional trackpad keys
to move the cursor.
Entering New Waypoints
WAYPOINT LIST
BELL POINT
COWES
WAYPOINT LIST
BELL POINT
COWES
NAB TOWER
NEW WAYPOINT
NAME ---------------------
LAT ---:--.-- -
LON ---:--.-- -
NEW WAYPOINT
2
def
3
ghi
1
abc
5
mn
6
opq
4
jkl
8
uvw
9
xyz
7
rst
0
delins
NEW_WPT
• If the waypoint catalogue is full, the new waypoint icon is
disabled until a waypoint has been deleted from the catalogue.
• If you want to return to the waypoint list without adding the
waypoint, simply press the exit ( ) key.
• To return to the edit display and display dashes, press delete .

AUTOHELM ST80 Specifications

General

Brand	AUTOHELM
Model	ST80
Category	Marine Equipment
Language	English