ST80 Masterview Operation and Setup
135
Response
This sets the response level when the autopilot is switched on.
D2666-1
Go to the Setup Exit page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
RESPONSE
3
The available response settings are:
(a) Automatic sea state control: 1
(b) Automatic sea state inhibit: 2
(c) Automatic sea state inhibit counter rudder: 3
The default setting is 1.
Unknown Cal Stage
The following screen is displayed if an unknown setup page is
accessed. Please contact your dealer for further information.
D2673-1
Go to the Pilot Setup Exit
page.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
CALIBRATION
STAGE
X
To Next Page
Loading...
