140 ST80 Masterview Operation and Setup
Pilot Status Icon Control
If you regularly need to know the status of the autopilot, the normal
operating icons can be set to disappear after 8 seconds of keypad
inactivity.
When the normal operating icons disappear, the autopilot status icon
is displayed above the right-hand key.
Key Beep
The Masterview, by default, beeps whenever a key is pressed. This
can be turned ON/OFF as required.
Display Mode
Display mode is used to select the operating mode for the steering
displays (for example, heading and wind steer).
D2675-1
Go to the next chapter.
Press for 1 second to enter
illumination adjustment.
Advance to the next page.
Press for 1 second to return
to the previous.
Highlight next display mode.
Select highlighted mode.
masterview
SET- UP
DISPLAY MODE
✕
FIXED
✓
CURRENT
• Current mode displays the current value below the bargraph
• Fixed mode displays the locked value.
To Next Page
Loading...
