ST80 Masterview Operation and Setup 83
Race Timer
The race timer is used to set a race countdown or count-up timer.
The timer settings available are: 5, 10 and 15 minutes (countdown
timers) and zero (count-up timer).
D2285-1
Advance to next chapter or
press for 1 second to adjust
illumination.
Next page or
press for 1 second to return
to the previous page.
masterview
Start countdown timer.
Cycle countdown times:
00:00, 05:00, 10:00 and
15:00.
RACE START
10:00
●
●
• The display head enters countdown or count-up mode when the start
key is pressed (the unit is now the race timer “master”).
Countdown Mode
D2174-1
●
●
Go to the next chapter
or press for 1 second to enter
illumination adjustment.
Go to the next page
or press for 1 second to return to
the previous page.
Stop the countdown timer and set
the timer to the next lowest start
time.
Re-synchronises the countdown
timer to the nearest start time.
• The synchronise key ( ) resets the timer to the nearest countdown
timer.
• The synchronise icon is displayed 20 sec. either side of a start time.
• The stop key ( ) is used to: stop the timer, reset the timer to the
nearest lower timer value, and return the timer to race standby mode
• The timer enters race running mode when the 5, 10 or 15 minute
countdown timers reach zero.
To Next Page
Loading...
Need help?
General
