AUTOHELM ST80 User Manual

114 ST80 Masterview Operation and Setup
Setting the Offset
Use the up or down key to set the required keel or water line offset
(the range is from -10 to +10ft).
D2214-1
Exit offset adjustment.
Decrease offset.
Increase offset.
2.6 Wind
D2215-1
Wind
Speed
Response
Wind
Angle
Response
Wind
Speed
Units
Display
Format
Offset
Adjust
PAGES
WIND
CHAPTER
Wind Speed & Angle Response, Wind Speed Units &
Display Format
Adjustment procedures for wind speed, wind angle response, wind
speed units and display format are identical to those provided in the
speed section.
Wind Speed Units
• The units for wind speed can be set to knots (KTS) or metres per
second (MS).
• The currently selected units are displayed upon entry to this page.
• The wind speed units are transmitted system-wide on SeaTalk.
Wind Angle Offset Page
This page displays the offset (port or starboard) entered when
aligning the wind transducer to your boat.
Note: On initial entry to this page the offset reads “0” and the wind angle is
the current wind angle (the current wind may or may not be accurate
at this stage, hence the wind angle offset procedure).

AUTOHELM ST80 Specifications

General

Brand	AUTOHELM
Model	ST80
Category	Marine Equipment
Language	English