ST80 Masterview Operation and Setup 39
D2251-1
Go to the next chapter or
press for 1 second to enter
illumination adjustment.
Press this key to go to the
next page.
Press for 1 second to return
to the previous page.
Switch between heading and
COG displays.
Tack Course
This page displays your tack course in degrees true or magnetic
(depending on your selection in User Setup).
masterview
D2252-1
TACK COURSE
TRUE
Go to the next chapter.
Press for 1 second to enter
illumination adjustment.
Go to the next page.
Press for 1 second to return
to the previous page.
120
• This page is not available if you have selected “power” mode.
To Next Page
Loading...
