130 ST80 Masterview Operation and Setup
Power Steer
Power steer is used to select the operating mode for a joystick:
proportional or velocity.
Proportional applies rudder in proportion to movement of the
joystick – the further the joystick is held over the greater the applied
rudder.
Velocity applies continuous rudder drive in the direction of lever
movement. To improve control, the speed of rudder movement
changes with the angle of the lever.
For maximum speed, push the lever hardover. If the lever is returned
to the centre position the rudder will remain at its current position.
D2656-1
Go to the Setup Exit page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
JOYSTICK MODE
OFF
The available settings are:
(a) OFF
(b) Proportional
(c) Velocity
The default setting is proportional.
Note: Please refer to the joystick and course computer handbooks for
setting up procedures.
To Next Page
Loading...
Need help?
General
