126 ST80 Masterview Operation and Setup
D2649-1
Go to the Pilot Setup Exit
page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
RUDDER GAIN
3
The recommended rudder gain settings are:
(a) Displacement craft: 5
(b) Semi displacement: 5
(c) Planing: 4
(d) Stern drive: 3
Rate Level
This feature controls the amount of rudder the autopilot applies to
reduce the turning speed. This is also known as counter rudder and is
only used with response level 3.
D2650-1
Go to the Pilot Setup Exit
page.
Decrease value.
Increase value.
Advance to the next pilot
feature.
masterview
SET- UP
PILOT
RATE LEVEL
7
The recommended settings are:
(a) Displacement craft: 7
(b) Semi displacement: 7
(c) Planing: 7
(d) Stern drive: 5
To Next Page
Loading...
