7. Advanced
meter (PR655, LMT, …) and at a fixed position during the entire measurement. In the procedure below we consider a system of 2
projectors.
CAUTION: Only to be done by qualified personnel ! Never change the values if not needed. Altered color
values will not guarantee optimal image reproduction.
How to calibrate Dynacolor for projector 1 ?
1. Press MENU to activate the Tool bar
2. Press → to select the Display setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Dynacolor
5. Press → to open the menu
6. Use ↑ or ↓ to select Adjust...
7. Press ENTER
A dialog box is displayed
Image 7-134
8. Press Calibrate in the Dialog box
A red full screen test pattern is displayed.
9. Press ENTER
A dialog box is displayed for the Red color
Image 7-135
R59770198 BARCO SIM 7D 13/02/2013 127
To Next Page
