Introduction
4 MC4 User Guide
Unpacking and Inspection
At the factory each new MC4 passes a careful inspection. It should
be free of scrapes and scratches and in proper operation order upon
receipt. The receiver should, however, inspect the unit for any
damage that may have occurred during transit. If there are signs of
obvious mechanical damage, package contents are incomplete, or
the instrument does not operate according to specifications, contact
the purchasing sales office as soon as possible. The standard
accessories are as follows:
• Calibration certificate,
• a warranty card,
• this User Guide,
• A CD-ROM with product information, USB driver etc.
• computer communication cable (USB),
• internal rechargeable NiMH batteries,
• battery eliminator/charger for the batteries,
• test leads and clips,
• a Cu-Cu adapter for millivolt measurement and
• if a pressure module (other than barometric) is included in
MC4: a pressure connector adapter from G1/8” female to
G 1/8” male with 60° internal cone.
For a description of available options, see MC4 Options on page 25.
If you have to return the instrument to the factory for any reason, use
the original packing whenever possible. Include a detailed
description of the reason for the return.
To Next Page
Loading...
