Tools Submenu
MC4 User Guide 149
Tools Submenu
The contents of the Tools submenu opening from the calibration
window menu's
Instrument Input
and
Instrument Output
options vary depending on the Function use for the input/output.
Full info of Basic State's Tools menu can been found in part B, chap-
ter Tools Menu on page 67. All of the following menu items also
have links to additional information found in this manual.
MENU ITEM DESCRIPTION
Function Info
Visible unless the Function is set to "No
Function". More information on Function
Info is in chapter Function Info on page 68.
Change Pressure
Module
Visible for pressure measurement Func-
tions only. Allows you to change the pres-
sure module during calibration. More info
on changing pressure Modules is in chap-
ter Changing the Pressure Module Dur-
ing Calibration on page 179.
Alarms
Visible for measurement Functions only.
More info on Alarm settings is in chapter
Alarms on page 69.
Damping
Visible for measurement Functions only.
More info on Damping settings is in chap-
ter Damping on page 70.
Leak / Stability
Test
Visible for measurement Functions only.
More info on Leak/Stability Test is in chap-
ter Leak/Stability Test on page 71.
Display Mode /
Specials
Visible for instrument input functions if
they are either measurement or generation
Functions. More info on Display Mode /
Specials is in chapter Display Mode and
Special Measurements on page 81.
Note.
The following Tools submenu items have additional conditions as to
when they are visible:
Damping
,
Leak / Stability Test
and
Dis-
play Mode / Specials
are available only before a calibration is
started.
To Next Page
Loading...
