Generating/Simulating
58 MC4 User Guide
Frequency Generation
The generated frequency is either a positive or an amplitude
symmetric square wave.
Function:
Frequency Generation
Check the
Waveform
setting. The percentage value is the
Duty
Cycle
setting (the ratio of the output high time to the total cycle
time). Also check the
Amplitude
setting.
The adjacent picture displays the
active terminals:
M e a s u r e
M a x 6 0 V , 3 0 V , 1 0 0 m A
T / C
m V
s e n s e
R , R T D R m e a s
V , I
,
V , I
,
T e m p e r a t u r e / G e n e r a t e
Note.
Due to technical reasons, the entered Duty Cycle setting is not
always realized. This happens with relatively high and low
frequencies. The true Duty Cycle percentage is shown in the
appropriate Basic Mode window.
See Appendix 1, Technical Data for more specific info of Duty
Cycle limitations.
Next
Pulse Generation on page 59.
Frequency Measurement on page 42.
Tools Menu on page 67.
Stepping on page 73
Ramping on page 76.
Calibration, see Part D.
To Next Page
Loading...
